The Casavent SRD-SR-90 is a sealing ring sized for 90mm semi-rigid radial ducting, used to provide an airtight connection between the duct and its adapter, flange, or plenum spigot. Fitting over the outside of the duct at the connection point, the ring is compressed by the lock ring or connector to seal the joint.
Keeping a few spares on hand is useful for any installation, since a properly seated sealing ring is what allows the push-fit duct connections throughout a radial system to maintain their air-tightness rating over time.
90mm
Duct Connection Size
Rubber Seal
Material Type
Compression Fit
Sealing Method
Spare Part
Product Type
System Component
This sealing ring is a small spare/accessory part used at duct-to-fitting connection points — it does not include the duct, adapter, or flange itself.
Airtight Duct Connections
Positioned over the outside of the duct at each connection point, the ring is compressed by the lock ring or connector to form an airtight seal between duct and fitting.
Rubber Seal Construction
Made from a rubber sealing compound suited to duct connection points in loft and ceiling void installations.
Simple Push-Fit Installation
The ring requires no tools or adhesives — it is slipped over the duct end before the connector or lock ring is fitted.
Useful Spare Part
Keeping spare sealing rings on site means a damaged or displaced ring can be replaced quickly without holding up an installation.
Matches 90mm Duct Diameter
Sized to fit 90mm semi-rigid radial ducting connection points throughout a radial MVHR or MEV system.
Product Overview
Brand
Casavent
Product Code
SRD-SR-90
Description
Spare Sealing Ring for 90mm Semi-Rigid Radial Duct
Fitting Type
Compression seal, push-fit installation
Dimensions & Material
Duct Connection Size
90mm
Material
Rubber sealing compound
What does this sealing ring do?
It fits over the outside of a 90mm semi-rigid duct at a connection point and is compressed by the lock ring or connector to form an airtight joint.
What is it made from?
A rubber sealing compound suited to duct connection points.
Do I need tools to fit it?
No — it is a simple push-fit component slipped over the duct end before the connector is fitted.
Why keep spares on site?
A worn, damaged, or displaced sealing ring can compromise the air-tightness of a duct joint. Having spares on hand lets an installer replace one quickly without delaying the job.
BTU & WATT Calculator
Room Dimensions
Room Type
Living Room
Bedroom
Kitchen
Bathroom
Conservatory
Hallway
Glazing Type
Single Glazed
Double Glazed
Triple Glazed
External Walls
0 Wall
1 Wall
2 Walls
3 Walls
4 Walls
Insulation Level
Poor
Average
Good (New Build)
Required Heating
0
Watts
0
BTUs
Tools & Kits
Need a full system?
Design your complete solution in minutes with our kit builders.